|
We are a leading distributor
of tractor mounted forestry equipment in North America. Products Include Tractor mounted
skidding winches and wood chippers. Log loaders, grapples, rotators and
forwarders. For more information on these products, click here.
Northeast Implement Corporate Home Page
Agric
Tiller PTO shafts
Fransgard
Norse Igland Tajfun Winch PTO Replacements
Patu
Junkkari Pete Kesla Woodchipper Replacements
Repalcement
PTO Shafts for commonly used equipment; rototiller, mowers, fertilizer spreaders, etc.
PTO
shafts for Valby woodchippers
PTO
shafts for Farmi winches
PTO
Shaft Pricelist
Tiller
Blades
Fiskars
Forestry Handtools
LogMatic Wedge Axe
How to order
Home
| |
Cutting a PTO for
use on a Valby Woodchipper
| PTO-Shaft. If the tractor has a PTO-Brake, you have to use an overrunning clutch. Click here for shaft recommendations for your model chipper.
|
| Cutting the PTO shaft to the
correct length. If the PTO shaft is too long
it might bind when the three point hitch is lifted up. Damage might be caused to the
bearing of the chipper or to the PTO of the tractor. If the PTO shaft is too long it must be cut. Both PTO halves must be shortened by equal
amounts. |
| 1. Mount the chipper on the three-point
hitch of the tractor. 2. Cut the engine
and remove the keys. Lower the chipper on a firm and level surface.
3. Lift the three point hitch so that the power intake shaft
of the chipper is on the same height as the PTO of the tractor. The PTO and the
power intake should be closest to each other at that position.
4. Pull the PTO shaft apart. Connect one half of
the shaft to the chipper so that the locking pin is locked in place. Place the other
end of the chipper flush with the end of the tractor's PTO. Lay the ends side by
side as shown in the figure to the right. Mark on the shield how much must be cut
off. The tubes must be so short that they cannot reach the bottom in any chipper
position. |
 |
| Cut the plastic tube. Refer to fig 7. |
 |
| Cut a piece from the profile tube, which is the
same length as the piece which you cut off of the shield. (As shown on figure 8) Shorten the other half of the PTO shaft to the same length.
File sharp edges off of the profile tubes. (As shown
in figure 9) |
 |
|
